5 replies
by jomuwalu_2 Accepted solution
by oldbaritone Accepted solution
Do you mean that you are trying to use the new WRT54 router as an Access Point, that it will be the third (or more) AP in a chain?
Originally I was going to suggest disabling the WAN side of the WRT54, but when I read again, I'm not sure what you're trying to accomplish.
I'm not certain I understand, but perhaps a Range Expander (repeater) would better accomplish your task. One example is linksys WRE54G. I don't know if you can get one, but it's a stand-alone device used to extend wireless coverage.
I'm not sure whether the WRT54 can be configured to do what you want.
by jomuwalu_2 Accepted solution
thanks oldbaritone. sorry for the missing parts. Am actually using the WRT54G
What I want to achieve is, the WRT54G (static IP address 192.168.1.1)is connected to the DW6000, it (WRT54g) then transmits the signal within it's radius. The task is for the AP600 wireless access point to be able to get the transmitted signal. The AP600 is assigned the static IP adress 192.168.1.2. Now on the WRT54G, I need to configure the advanced routing settings so that it can send the signal to the AP600.
What fields on the advanced routing page do I need to change?
by cg it Accepted solution
by jomuwalu_2 Accepted solution
I need the WRT54G to communicate
with the AP600 access point, that is right..
This discussion is closed to new replies.
Trending Software posts
Sort by Trending