7 replies
by allan
by shs_bulldog
by huvason
by shs_bulldog
by smurfman
The CISCO cable that is shipped with a CISCO router is a rollover cable, for use on the console port. This is not to be confused with a crossover cable. Try setting the connection to be 8N1 and at a BRate = 9600. Additionally make sure that the terminal options for that connection are set to echo what is typed. Additionally make sure tha the connection setting is set to VT100 (Ansi). By doing this you sould be able to see what is going on. I am assuming this is a new router? Or does it have an IP address already? If it does, and it is on the network, try telnet to the ip address and log in that way. Else, make sure the cable is the right one/type the 3Com should have some with one. Hope this helps.
Smurfman
by shs_bulldog
by shs_bulldog
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending