Discussion Locked

How to enable onboard 100BTX on HP C200

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Running HP-UX 10.20 on a HP Visualize C200 workstation. How do I enable the onboard 10bt/100btx ethernet adapter?

3 replies

by cpfeiffe

You need to use lanconfig from the command line. The man pages on lanconfig will assist you with getting all of the settings right. If you want to use a GUI you can launch sam and go into Networking and Communications. Good luck.

by ninet4

Thanks for your help. Turns out all that I had to do was plug the cable in to the correct connecter and the system would automatically see it.

This discussion is closed to new replies.