Discussion Locked

How to get a file from Unix to NT?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

How would i go about either:
1. Pushing a file from Unix box to NT box
or
2. Pulling a file to NT box from Unix box

ftp solution? (last resort is NFS).

5 replies

by gutridgesj

for #1, you need an ftp server such as in IIS before you can FTP from anything to the NT box. Or, their are some shareware and payware FTP server out there that run on nt.

for #2, it is the same

in both cases you asking how you can ftp a fileto NT. pulling (get in ftp) or pushing (put in ftp) is irrelevant.

but, if all you want to do is ftp files between the boxes, then just ftp from the NT box to the Unix box since Unix comes with an ftp server.

In NT, drop to a dos box, type in

ftp xxx, where xxx is the IP or host name of the unix box, log in to unix, set the transfer type (either ascii or binary), use the put command or get command depending on whether you want to "put" a file from NT to Unix or "get" a file from unixto nt. the help command will help you with commands.

This discussion is closed to new replies.