Discussion Locked

How to get a Linksys 10/100 NIC to work

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have installed a linux box in my office on an old P100. I used 2 Linksys 10/100 NIC cards which work fine. I went home and installed one on my PII400 with no luck. The tulip driver won't work. It's detected but is unreachable. Any suggestions?

2 replies

by zbrain75

You probably have a resource conflict between your network card and some device on your PII400. Ask yourself, what devices are you using there that you did not use on the P100? Also is there a SCSI controller or extra CD-ROM?
You can review the /var/log/messages file to help you determine what IRQ are assigned to which devices. Also be sure in your BIOS, PNP mode is disabled which can cause problems.

This discussion is closed to new replies.