Discussion Locked

how2 clone server

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We just got a new server to replace an old one running winnt4.0.(it's also the primary domain controller)
Is there a way to clone the old server, to the new one???
Both have a raid and both of them are intels.

2 replies

by dannyboyisalsomelancolic

Let's start with your raid controller:
If your purchased a new model, there is no way of saving your raid conf., but if they are the same model, you just need to move the controller and the disks to the new server. It can be, that there will still be some differencs reguarding the HW like display and network adapters, but the essential is to be able to start NT, the rest can be solved later.
If it is not possible to move raid+ disk, you will need to configurate the new raid system first, install a temporary NT (don't name the NT directory the samme name as on the old server, make the partitions equal or bigger as on the old server, and then restore your backup. If your hw uses special or newer drivers than on the old server (it is important specially reguarding your raid controller), your will need to install this drivers on the old system first, run a total backup, and then restore it on your new server. If your have others Domain C. in your domain, you better promote one to be thepdc, before starting this operation.

reguards

Danny Bar

by rzan

Powerquest, the makers of PartitionMagic make a great product for NT and Netware servers called ServerMagic. It allow you to resize volumes, block sizes, and also allows you to completey clone an entire NT or Netware server drive partition. Another solution is Norton Ghost Enterprise Edition which will generate a random SID for NT clones and can also allow you to set up a cloning controller server which you can use to make many clones using a pure IP connection.

This discussion is closed to new replies.