Discussion Locked

Hp 5800 will not boot

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hi...the set starts counting ram and will not go into setup.... then a blue screen with the words "Smart Card Authentication" and below "Smart Card reader not present" cannot get anywhere further and this Hp 5800 does not even have a Smart card reader....heh what the heck could it be the power supply? Processor is warm all fans work rams are ok all drives are ok monitor fires up...... no function for setup bios will not fire up hard drives .....all windows systems are not accessible maybe mother board?...i'm stuck.*john

5 replies

by kees_b

Something wrong indeed. But since model 5800 from HP can be a switch or a printer, it's quite unclear what. All I can advise: find a repair shop.

by birdmantd

I must agree that there is not enough information provided to offer any additional/constructive advice or to identify the potential issue. What type of device is this? How old is it? Did it previously work without any such issues? Is it still under manufacturer warranty? Try again.

by rproffitt edited

The only reason to replace it is if it's doing some work as a CNC controller and the software was locked to that PC.

Otherwise and mind you I'm talking about here in N.A. you get a working one off e b a y.

This discussion is closed to new replies.