8 replies
by hal 9000
Well if the paper handling isn't the problem it is the imaging circuitry that has gone bad.
So start at the beginning check do a test print from the printer to see if the problem still exists
http://h20000.www2.hp.com/bc/docs/support/SupportManual/bpl06356/bpl06356.pdf {page 24}
if it's fine then start looking for other reasons and first check the data lead to make sure that it isn't damaged and if in doubt replace it. If that doesn't cure the problem it's time to dig into the guts of the thing and as this isn't a little printer that is a play toy you're best off getting a HP tech to fix it up if there is one available.
As this has several options to connect to the computer/network you might like to take advantage of a different connection method there is a Parallel, RJ45, Fast Infra Red Connector and a C-Link so if one isn't working you should first try another connector to see if that one works. If it does the most likely problem is in the original connection socket.
Just a hint here as Canon makes all the HP Printers you might get some more help out of them for the Canon Branded unit than out of HP.
Col
by hal 9000
by denghoffer
Poster rated this answer.
If you print a menu map in Landscape the print is fine on the top, fine on the left side, scewed on the bottom. From left to right the line on the paper goes at an incline.
by denghoffer
by denghoffer
by hal 9000
Well as you have a solution do not forget to close the question.
If you can not purchase the required part from HP you can always try Canon as they make the HP units and may have the part if you can give them the equivalent Canon Model number.
Col
by denghoffer
Poster rated this answer.
by denghoffer
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending