Question Locked

HP LaserJet 5000

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have 3 different 5000 series printers that are all doing the same thing.
They will print fine for a while, but then they start cutting off part of the page. Sometimes up to half of the page is blank. We have replaced power supplies, laser assys, jet directs and circuit boards with no success.
Does anyone have any ideas what might cause this?

3 replies

by dlogan

We are having the same issue which started immediately after replacing the hp toner a few weeks ago. From my research from whats available online nothing works. I found that after I move the spring loaded connecting pins for the toner cart and I blow these out make sure they move freely the issue goes away for a week. Not too many people have this issue. I ordered one more toner to see if it was a bad batch. Because it sounds like an intermittantly bad drum. Still working on it. The jurys out on this one.

by theyshotfritz

Actually after a couple of us have replaced just about everything in the printer we noticed something. There is a small flag sensor near the registration assembly. The flag senses the paper going thru and tells the laser when to fire, if the flag is worn out then it lifts too early and the laser shuts off prematurely, causing the partial pages. Something you may want to check. Hope that helps anyone that is having the same issues.

This discussion is closed to new replies.