Question Locked

HP LaserJet 5p printer problem

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
The printer is printing 1/8" wide black lines every 3" across all pages. Any solutions would be greatly appreciated. Thanks, Charles

6 replies

by oh smeg

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=au&taskId=110&prodSeriesId=25481&prodTypeId=18972&prodSeriesId=25481&objectID=bpl10515

[i]edited[/i] TR seems to be breaking URL's again so try this link if you have any problems.

http://tinyurl.com/24hufed

This however is generally related to dirty parts inside the printer. Things like Rollers or distorted Wipers tend to be the cause of things like this,

When these things happen you need to remove all cartridges and Drum and clean out the unit. Also look for damage to the Drum and if there is any present you'll need to replace it.

Col

by arthur.acopians

I would start off at the toner and rollers. I have a 4m and it does that once in a while. I take the toner out, move the cover back and, with a lint free cloth, wipe off the residue.

by michael jay

prints badly, clean up the printer and it still prints badly you could get it printing clean again with a maintenance kit.
http://www.printerworks.com/Catalogs/Maintenance-H-Kits/5P-MK_Maintenance-Kit.html

At close to 300 bucks these kits can give new life to the old printer, alternately and depending on your printing needs, buying a new printer may save you some money up front and in the long run.
http://www.shopping.hp.com/webapp/shopping/can.do;HHOJSID=Wd56NlTKgC1BvyGnHdJ0KsWjjJTQStT8Lrg4r6QwbcM0vSnQ6Vm7!1867813698?landing=printer&category=LaserJet&catLevel=1&storeName=storefronts

by hquist

MAke sure the CORRECT driver is installed and the right settings made ( paper size, print area from application) also check if the toner cartridge needs to be replaced. that should solve it.

If not, check the fuser unit to see if it has developed abrassions and replace it.

by choppit

You can tell a lot by the spacing of marks/lines on laser printers. If they're identically spaced try rolling up the paper so that 2 adjacent marks overlap. This will give you a good idea of where the marks originate from if you compare the diameter of the rolled up paper with the various rollers in the printer (fuser, drum etc).

This discussion is closed to new replies.