Question Locked

HP Pavillion DV1000 NO POWER! HELP

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Can anyone help?? I went to start up my laptop- and it was basically dead- absolutely no power at all. We checked outlets, connections, battery in and out, called HP and went through a bunch of things- none of them worked. The cord is fone- was tested and it is sending power out- but it refuses to turn on at all. Has anyone else had this problem? Before I sink a bunch of $ into it, I would like to try to fix it on my own!!! Please advise????

7 replies

by bart777

Most laptops run the power thru the battery to the laptop even when plugged into the wall. If the battery is bad it will no allow the power to flow thru.

See if there is another battery around that you can borrow from some other laptop. If it still fails at that point the MB is going to be bad.

by whatizreal

I have a similar problem. What should I do if an hp pavillion dv1000 just powered off all of a sudden. The technicians at a local shop have tested the battery and the power cord and hard drive fine.

I'd like to put the hard drive in another machine and back-up the date before I turn it over to them for "surgery". Am I only able to use another DV1000 to read the hard drive or can I just get close without risking damaging the hard drive?

by bart777

Go to the local computer store and get a USB converter.

This is a device that will allow you to attach your hard drive to another PC via a USB port. All you do is pull the drive, hook up the cables and backup your data.

Here is a link to a similar device.
http://www.newegg.com/Product/Product.aspx?Item=N82E16812232002
Make sure you get one that will do both standard IDE and the smaller laptop connectors as well unless your aptop had SATA in which case you're good to go.

Good luck

by justme7

I found a problem in my hp dv1000 laptop!
My laptop shutdown on me as well. I tried everything and even after hard reset (hold down power for 30 sec without battery or chord) it would fire up and die within seconds of getting to Windows screen.

I've tried removing ram, wifi card, hard drive - and i got black screen but at least power was up and bios beeps 3 short then 1 more short beep. I found out online that is was for read/write to ram problem. Well of coarse that was no ram inside. duh...

So i installed one stick of ram and rebooted again, now I've got video and it booted to the screen where it looks for boot device and since hard drive was missing it went into continuos cycle of trying to find something. So I powered it down. Installed old harddrive and started it up again.

Well 3 seconds later it died on me again. So I removed hard drive and did a hard reset again. Then I made a bootable usb drive with linux on it and started it up again and I was able to get into Linux and perform all the tests.

My battery got changed up and I let it sit for a while to see if its going to die again and it did not. So I found that the problem was in bad sectors of hard drive or maybe badly damaged disks inside hard drive. So I bought a new hard drive and everything works fine now!

I hope this helps.

This discussion is closed to new replies.