Question Locked

HP printer personality

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We have an HP 952C Deskjet printer. It's been a work horse and given us good service. Yesterday I was printing a PDF and the print quality went down hill. I changed the black cartridge and it helped but will I was changing it I noticed that it needed cleaning badly. So I cleaned it up using H2O and a rag. I left it to dry overnite and this morning when I fired it up everything seemed to work Except... Now the printer thinks it's a 970 instead of a 952C. When it prints a test page (from the front panel) it says it's a 970 and when I plug it into my laptop (running win98) the new hardware window comes up and says it has discovered new hardware an HP 970 printer. I've tried all of the obvious solutions, power cycling, resetting factory defaults, I even tried downloading 970 drivers (no longer available according to HP's web site).

Anyone out there know how to reset the printer firmware so my 952C can be a 952c again?

Thanks,

Tomw

5 replies

by triathlete1981

the printer only thinks it's a 970 when you connect your laptop to it? does the printer do this for other operating systems? did the 952c come out post-win98? was the 970 the win98 version of the 952c?

your printer's possessed. i've never heard of anything like that. but if it's still printing a test page, then it should be printing all documents, be it a haunted printer or not.

by tomw

The printer thinks it's a 970CSE without being connected to anything (i.e., if I hold the paper feed button down for 5 seconds it prints a test page that states it is an HP 970). The printer is a win98 era machine. The laptop (win98) "New Hardware Found" window id' it as a 970. The 970 is(as far as I can tell) a later machine (models ran 950 series-960 series-970 series). Last but not least I plugged it into an XP machine and it came up in the "New Hardware Found" as a 970cse. I installed it and loaded the driver and it works like a champ. The problem is that the win98 drivers (for the 970) are no longer available from HP. So I can't make it work with the laptop it was dedicated to.

On the other hand I'm thinking of starting a new business "send me your printer I'll give it a bath and a free upgrade"

thanks for your reply - any other ideas?

by tomw

Well the problem is resolved. 3 hours on the phone with HP India and we finally convinced them to send us a link for the 970 driver (our little 952 is an all grownup 970)... As it turned out the win95 driver for the 970 is still available and works for win98 systems...

The moral to the story I guess is if you want a newer printer just water it... Wait 24 hours and power it up Ta Da... Insatnt upgrade...

Tom W

This discussion is closed to new replies.