Discussion Locked

HP ze1210 laptop power jack

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently obtained a ze1210 laptop that had the internal power jack busted. I didn't do my research and just purchased a generic dc jack from radio shack. I have connected the two of the three posts (i was only certain about the polarity of two posts). It works fine, as long as i don't insert that battery, when that happens I lose power. The battery also will not charge. My question is do i have the correct part, or is there something special about the original laptop jack that a generic jack does not have, or can someone help me out with the polarity of the third post. the generic jack that i have installed has a third post but it looks to be redundant, no special switch or anything. do i need to just connect this third post to the other unconnected post? any help would be great!

Thanks,
Pratt

4 replies

by hal 9000

There should be a switch inside the jack which switches from Battery to mains power and the third contact allows the battery to run the NB when there is no mains power available. Connect up all three contacts and it should work as you already have two connected and the NB is running with mains power it should be a simple job to solder in the third leg to get the unit working properly.

By the way you'll not actually see the switch in the jack as it is on the negative side and looks like the negative contact and when the power plug is inserted it breaks the connection from the battery you can only check this with a multi meter not visually.

Col

by phinds

OK, thank you HAL 9000. I said this answer didn't help me only because it didn't solve my problem, not because it was wrong. I figured out the switch mechanism, made the connection, and the laptop still shuts off when you insert the battery. I have not see a bad battery do this before and am not convinced that the battery is bad, has anyone else seen this before? The battery charge light comes on, but after a bit flashes on and off randomly and then will go off completely. If you try to power the laptop on at this point it will not do anything. You must first unplug the laptop and take out the battery to get it to properly function. Any help would be great. Thanks.

Pratt

by marcus

Either the power adapter you're using is too small to begin with or it's not working properly. It most likely does not provide enough wattage to power the computer AND charge the battery at the same time. Every now and then we see a computer come in for a DC jack repair where the customer has also provided an adapter that is either dead or damaged to the point it won't provide enough power for the laptop.

by the_idman

I have owned my HP zx5000 for a little over a year now. It was dropped (about 2 feet) and everything was working fine untill about two weeks after when the batter wouldn't charge. Now when I put the battery in, my laptop does the exact same thing as you described; light comes on for about three seconds, then blinks for about ten and then the laptop shuts off with no warning. I don't know if it's just a coincidence with dropping it or what. Like I said, the battery worked fine after it was dropped for about two weeks. I hope you have solved the riddle and can give me an answer.

Thank you,
Jason

This discussion is closed to new replies.