Hubs and Switches
Please tell me the main fuctions of HUBS and SWITCHES and where specificaly to use Switches.
Thanks
Networks
Please tell me the main fuctions of HUBS and SWITCHES and where specificaly to use Switches.
Thanks
by donte
by shabirqadir
There's too much to cut and paste, and there are illustrations as well. Follow this link for a great comparison and description:
http://www.enetdepot.net/hubandswitch.html
Another hub vs. switch comparison:
(REMOVE SPACES from the pasted URLs.)
Good luck,
Maxwell
by shabirqadir
by highorbit
Both Hub and Switch provide one basic function, which is to provide simple communication between all the devices attached to it. It will not Route data, unless you have an expensive one!
There is a very basic difference between modes of operationof the two devices.
A Hub is a simple device that upon recieving a packet bound for another device on the network will broadcast the packet on all ports and let the devices decide which wants it.
A Switch will look at the packet and read the destination MAC (Media Access Control) address and only send to that address.
With that in mind it is possible to have more than one device communicating over the network at any one time with a switch, whereas a hub is limited to one.
There are also security implications with Hubs, as it broadcasts any network communication on all ports it is possible to snoop on the traffic passing over it with a packet sniffer, and alter the packet should you want to. Switches are not prone to this because the sniffer would only see traffic bound for it.
As for where you use them, that depends on the network traffic and whether or not you want to watch the packets going accross them, in general though a switch is more desirable as it is 'cleaner'.
A very large network will suffer large drops in speed if the core relies on a hub rather than a switch.
by shabirqadir
by mike mullins
The answer you're looking for is right here on TechRepublic. Go to
https://www.techrepublic.com/article.jhtml?id=r00220010607mul01.htm
It's titled "Use the OSI reference model to aid in topology decisions"
It covers both switches and hubs and all the other network components.
Cheers
0 bytes
by mike mullins
by shabirqadir
by csmith
The link in #4 is not currently posted.
The only serious advantage of switches, is that they cut down collisions, and thus network efficiency rises.
They do not affect bandwidth.
If you have two heavy simultaneous uses, you still have to segment the network.
Regards, Chris
by csmith
:
The Article is now reposted.
Yes, the spaces were out.
Regards, Chris
by shabirqadir
by mferrel
by shabirqadir
by clrichardson
For where to use them, I would use switches instead of hubs everywhere I could for the speed advantages, especially for a backbone and directly connected PC's and servers.
Switch ports have the ability to go into "FULL DUPLEX" where they can increase the potential bandwith from 10mps/100mps to 20mps/200mps for each port. This means that the attached device (another switch or NIC) can transmit (10mps/100mps) AND receive(10mps/100mps) at the same time. That's where the increase in bandwidth comes from.
Some switch/NIC combinations take this a step further and can combine ports/NICs to create even higher bandwidths, ie: four switch port/NIC pairs each running full duplex @ 200mps are combined for 800mps to a server or into the network backbone. Now figure this using 1000mps(GigaBit) stuff!!!
A hub is "HALF DUPLEX" only. It EITHER transmits OR receives. It cannot do both at the same time.
by shabirqadir
by shabirqadir
This discussion is closed to new replies.
Sort by Trending