Discussion Locked

Hyper terminal

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have win98 on one of Workstation in the network with modem, when I try to use Hyperterminal to transfer files to our remote sites, I receive common error message (the program has performed illegle operation)
and in detail I read following.
HYPERTRM caused a general protection fault
in module GFXDRV.DRV at 0001:0000730b.
Registers:
EAX=00000000 CS=033f EIP=0000730b EFLGS=00000246
EBX=00000000 SS=5a37 ESP=00007910 EBP=0000794e
ECX=00000000 DS=3557 ESI=ffffff7c FS=4b7e
EDX=00000000 ES=0183 EDI=d4417828 GS=0357
Bytes at CS:EIP:
67 66 8b 0c 33 66 33 d2 8a d1 66 c1 e9 08 67 65
Stack dump:
000079a4 0000964a 00180000 00180008 001800ff 00000000 00000000 05d70003 07a57976 964a0477 001805d7 00000084 00000030 e21b1528 d4417528 79c605d7
Please help to overcome with this error.

11 replies

by andy_p

GFXDRV.DRV is the display graphics driver.
Configure you machine to work in Standard VGA mode then test hyperTerm.

If everything works OK, then it's time to update the Video drivers your using or firmware, I seen this issue serveral time on 3D card mainly from Intel.

hope this helps

Andy

by gregc

The file GFXDRV.DRV is the driver for the INTEL 740 graphics accelerator chip. You need to get the latest driver for your video card or you can get a driver from Intel. Hope this helps you out.

Greg

by ozzg

I once had this card on a computer and after 2 weeks of major problems with it, it was pulled and replaced with a better card. Is the problem only happening when you are transfering files or other times in that program. Also, is it uploading or downloading or both? Is this a new problem or is it one you have all along. Have you tried going to http://support.intel.com/support/graphics/intel740/
to download the most current drivers?

by nate hoy

For a simple fix, you can try sliding your video acceleration down. Go into control panel, system, and under the performance tab click on the video button, and slide the tab to the left.

Reboot and try it again. This is a harmless fix and will tell you quickly if you need a new video driver.

This discussion is closed to new replies.