5 replies
by saidmaamri Accepted solution
by tobif Accepted solution
...that ftp uses TWO TCP port numbers.
Usually 20 and 21.
This protocol was developed just a couple of years after the stone age, while there were:
No NAT routers
No man-in-the-middle
No Malware
It can be tricky to get a ftp server to work well from behind a router even without moving it to another port number.
(But, if you can use the standard port number, then many routers will figure out and do the needed magic for you).
I'd suggest you try a different approach. SSH, perhaps?
EditAdd:
Or look at Hamachi, VPN or something, to break the barriers and secure the connection, and then run your ftp session the normal way.
by slayer_ Accepted solution
to the private IP.
You can only use your private IP if you are inside the network, not outside it.
by tobif Accepted solution
OP's ISP connection filters incoming TCP traffic to these ports (as far as I understand).
So, the way around could be VPN/Hamachi style channeling.
by robo_dev Accepted solution
See the article:
"Using Non-Standard FTP Port Numbers with NAT"
http://cisco.biz/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e76.shtml
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending