Question Locked

I need to recover data from a corrupt raid 5 array

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

This is my first post, I hope someone can shed some light on the current situation.

I have a Dell PowerEdge 2800 with a Raid 5 configuration with 3 x 286 GB Hard Drives. I initially was going to use this as a desktop so I installed Vista and created a 80GB parition (C:\)for the OS, then through the OS I formatted the second partition (D:\). I saved a about 40 GB of important data to (D:\). When I found out about video card limitations on this system, I decided to install SBS 2003 premium. I started the instsall for SBS and selected the (C:\) and also selected to replace the current OS (Vista) and format the the drive with NTFS (Quick). After loading all the setup files it did it's first reboot. Upon the first reboot the system no longer recognized the raid array. Since the server is still in warranty, I called dell. (Possibly a huge mistake). Dell had me try everything under the sun, which may have made things worse. They had me force offline disc 2 of array (0,1,2), and then clear vram on board, then clear raid config...none of this worked or helped. Then Dell had me pull out disk 1 and 2 and install and OS on disk 0 to see if OS would pick up other drives. Non of this helped. They bascically couldn't do anymore after 5 hours and suggested that I contact http://www.ontrackdatarecovery.com, which wants a $2,000 initial fee and said that it would costs between 15-25K to recover the data. Does anyone have any idea how to recover the data from a corrupt Raid 5 array other than spending 30K? PLEASE HELP!

3 replies

by Former member

My answer to you is that your system is wiped. Reading your post and with "dell" telling you to do this and that (of which you did) then i would say there is no way to retrieve except to take it to ontrack. There is another way but this means that the disks are in there original setup and not wiped, it is possible to put them together with the raid 5 drivers, but you only have one shot at this, so you would have to know which disk is what in the setup i:e master/slave etc. You could just load on the operating system on to another hdd and then load on the motherboard drivers with the raid drivers and go from there. If it is ok you should be able to read from your raid drives, if so them do a full backup of your files so that you do not have to worry in the future.
I hope this helps you.

by shellipe

Slave the raid drive into another system...any system and recover the data by accessing the new drive letter of the raid drive and going to the location of the stored data.

This discussion is closed to new replies.