Discussion Locked

I/O Conflict

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When booting up my Windows 98 system I receive the following error as listed in title. It then asks me to choose F1 or Setup. If I go into setup I see that address assigned to an Onboard Serial Port 2. I don't see that address assigned anywhere else. I have also checked Device Manager but don't see a conflict. The end result of all this is that my modem will not initialize and I am not able to get online. Any help would be appreciated. Thanks

14 replies

by clover252525

Do you have an internal modem? If you do the chances are that it is set for COM2. In that case you need to disable the COM2 port in the BIOS, then your modem will work fine.

clover

by mphoffar

Poke around in the bios. Somewhere in there there's probobly an assignment for a modem IRQ and address. On mine it's under PCI devices, but it really could be anywhere in there.

Heck, if anything deisable com2. If it's an internal modem, themodem should create it's own com port for use on the system.

Mark

by mckaytech

It sounds like your modem has a fixed (jumpered?) serial port on COM2 and your motherboard has it's eye on using the same port. The best approach, if you don't need the port otherwise, is probably to disable the Onboard Serial port in the BIOS.

This is kind of an interesting twist because normally it's the IRQ conflicts that show up rather than IO and that makes me wonder if there is something strange about your BIOS or modem or both in regards to PlugNPlay support. So you might want to also check that both are set for PnP operation rather than a legacy mode.

paul

by jchabtraining

If this is an internal modem that has jumpers on it to choose the com port, remove the jumpers, make sure you remember where they are if this doesn't work. Go into device manager and remove the modem. Shut down and reboot your system and allow windows to automatically detect it and install drivers. This should solve the problem. If it doesn't good luck.

by dlm

I agree with answer #1, however, after you disable com2 in the BIOS, you will have to boot up into windows. check to see that there is NO com port 2 listed in device manager, if there is, remove it. Then you need to run add hardware wizard, if it detects a communications port(this port is actually coming from the modem)then your done, your modem will work.
Another thought is why this error condition occured, if it continues, you may need to replace your CMOS battery, if it never happens again, chalk it up to one of the many mysteries of computers!!!

by yozzy

Please specify what bios do you have
if your bios seemed to work fine and you have never messed with it, try the restore defaults option usually available in award and AMI, otherwise please tell us more about the BIOS.
if this does not solve the problem check if your modem is PNP, if not check the jumpers ( has the modem been working before or is it new ) ETC...

by yozzy

I guess your driver is the problem
i would recomend removing the drive from
control panel - systemthen refresh and install the driver again

This discussion is closed to new replies.