Discussion Locked

i/o conflict (2f8)

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

changed the system board on my pc.newer board
had ps/2 mouse,other one had serial mouse.
installed the video card,sound card,which is funtioning xcept when i install the modem it
tells me i/o conflict @2f8 which is the address for the 2nd communication port.any help in how to resolve this will be app.
--------------------------------------------

6 replies

by kalél -- mcp+i, mcse

You'll need to start the "BIOS Setup" and disable or reassign the integrated Com-2 port I/O port address.

Check your motherboard manual for instructions on how to start the "BIOS Setup" routine, and the specific manner of changing port assignments.

You can use the older serial mouse on Com-1, or you can install a PS/2 mouse to free up the first serial port.

It may be possible to reassign your modem's com port address, but it's my guess that the above would be less problematic for you in the long run.

by ninewands

If your modem is a Plug 'n Play device just relocate it to COM3: and use the system properties device manager to change its resources so that it uses an unassigned interrupt vector (IRQ) other than 4 (I usually use 10 because my sound card is extremely possessive of IRQ 5). This should take care of your problem without having to disable or reconfigure anything in your CMOS setup.

by azizhakim

THANX A LOT.WHAT I DID WAS REASSIGN COM1 TO
COM3/3F8 & INSTALLED A PCI MODEM.THE NEWER BOARD PERHAPS DOES NOT ACCEPT THE OLDER 16 BIT MODEM.IS THAT A LOGICAL EXPLANATION

by drew_lgca

If you used the same hard drive with the same OS. I would reboot in safe mode (press F8 while booting up) Go to device manager (start =>settings=>control panel=> system and delete any device that are not install (there will be old stuff from your other motherboard. Also make sure you delete the comm mouse and modems. Restart machine and re install the modem. make sure that you have the driver disk and win98 disk. If it not a PNP modem there might be jumpers on it or software to configure it. Check the modems web page or windrivers.com

This discussion is closed to new replies.