Question Locked

I want to Run Windows Server 2003 on a Serial ATA Raid, what should I know?

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My subject pretty much explains it, but what I'm trying to do is set up Windows Server 2003 on a Serial ATA raid. I'm buying all the parts brand-new right now. The motherboard I was planning on getting is an Intel DQ965GFEKR Socket 775 MicroATX Motherboard. An unreliable source told me some motherboards don't boot off their Serial ATA's; I believe that's just the older motherboards, this one is quite new and setup to run a Serial ATA raid, so I doubt that should be a problem. Though another issue I'm not sure of is the installation of Windows Server 2003, will that automatically be able to recognize my Serial ATA hard drives or will I have to monkey with some weird drivers and floppy disks? I'm afraid of floppy disks. Anyway, I just wanted to know if there was anything I should know. Thanks for your time.

|\/|ark

6 replies

by jkerby

As with all hardware based RAID, you will have to setup your raid controller and drives first. When you boot up the system. Enter the BIOS and set the SATA drive configuration to RAID. Upon reboot a prompt will appear when the RAID controller is recognized by the BIOS. Hit control-I to enter RAID configuration. Configure your RAID as needed, say simple RAID 1 mirroring.

At the beginning of Windows Setup, press to install a third-party SCSI or
RAID driver. When prompted, insert the diskette labeled Intel Matrix Storage
Technology RAID Driver.

After that the OS (Win, Linux, UNIX, etc.) are not aware that a RAID exists. In other words, the OS only sees a raid as a single drive. For example, if you setup a mirrored RAID across 2 100GB drives with a hotswap spare, the OS will only see a single 100GB drive.

by dr.llvll

Thanks for your response it was very helpful, but I still have one question: You were talking about a diskette labeled: "Intel Matrix Storage
Technology RAID Driver." I did not get a diskette with my motherboard or my harddrives. Where should I go to get the diskette to set up the raid? I did of course get a CD with my motherboard, but I don't think that's what you are referring to.

by langlier

1. The hardware vendors website will likely have the SATA/RAID drivers you need.

2. If you received a CD it is likely to have the drivers on it.

by dr.llvll

You were talking about the CD that would be the Motherboard CD right?

This discussion is closed to new replies.