Discussion Locked

IBM 300GL won't boot after mem upgrade

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an IBM 300GL w/ 256M memory running Linux. I installed another 256M memory chip. When booting up, I see that the BIOS sees the memory in the upper left corner showing "RAM = 0512MB" memory and then I get black screen with the upper right screen saying "B8" and the boot goes no further. Does anyone know why the boot hangs?

6 replies

by oz_media

Hmmm,searching B8 under a few source including IBM's support for your desktop returns nothing.

I would definitely say it is a mamory error.

IBM are VERY VERY picky about RAM, aftermarket RAM does not like thier proprietary desktops.

Are you sure it is matched to the existing RAM?
Is the front side BUS the same?
Is it CHEAP aftermarket RAM?

I would swap it with the known working RAM and see if it boots without the two stcks but just the new one on it's own.

Ensure you hae the latest IBM BIOS update installed too. Just visit IBM support and enter your machine type AND model number, as shown here,
http://www-1.ibm.com/support/docview.wss?rs=0&q1=300+gl&uid=psg1MIGR-4CKQL2&loc=en_US&cs=iso-8859-1&cc=us&lang=en
this BIOS is for IBM 300GL (Type 6563, 6564, 6574, 6593).

I would try running it on just the new RAM and see what happens though, then if it works on the old but not the new, your problem is narrowed down to defective or incompatible RAM.

by annie_chang

Thanks for the suggestion. I've tried it and it doesn't work with the new RAM. I bought Corsair brand RAM from Fry's - I don't think it's particularly cheap but I'll try to find some original IBM RAM.

by jaqui

Oz is right,
IBM requires IBM ram.
it's one reason I avoid big name computers, proprietary expensive hardware.
( proprietary bios is the other )

all you get for buying ibm over no-name is the name.
no performance benefit. not a lot of support difference. not really any quality difference either anymore.

by jdclyde

UPGRADING memory on an IBM server.

I hit an issue about a year back.

You first have to check what the system wants as far as configuration. They are picky as far as what combinations you can put in.

First, boot with just the new memory. If that works the memory is accepted, just not in that config. Also there is a difference between PC and Server memory. Can't interchange.

http://www-132.ibm.com/webapp/wcs/stores/servlet/ProductDisplay?productId=1875078&storeId=1&langId=-1&catalogId=-840

http://www.ec.kingston.com/ecom/configurator/models.asp?root=us
Go to this second link and put in the exact server you have and it will set you up with the correct memory THAT GOES IN THAT SERVER. This is not a generic thing.

Good luck.

by annie_chang

Thanks for your suggestion. I also eventually found on the IBM's site that my machine can only have a max of 256MB RAM anyways. So I'll save that machine for non-server use.

This discussion is closed to new replies.