Discussion Locked

IBM 3916 and Netware printing

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Novell 4.11 network. A jetdirect card configured and an IBM 3916 laser printer connected. I can't get any real print from this printer. IBM says to use a LJ4 print driver from Windows. But it still wont print all the time.

I've switched printers so I know the network and Jetdirect are config properly.

I beleive it must be a config on the printer end. I've tried so many, but can't get it to go. If you have this setup and can send me the config from your printer I would appreciate it.

Thanks
TM.

5 replies

by estebandelatorre

Where is the Jetdirect card instaled? into the printer?
Jetdirect cards are suitable only (as I keep in mind..) for HP laser hardware, not IBM

If it's and external printserver it should work.
The win95 wks must have the IBM drivers installed (not HP drivers!!!)
Then connect the printer to the LPTx to ensure printing.
Then change the port of the printer to match the printserver definition.
a.- You're done
b.- Nothing happens
c.- Some printer activity, but no page.

Answers to:
a.-Go Home!
b.- Check: Prinserver definition, Nw queue asignment. Delete everything! and start it again is the Best.
c.- 100% Driver problem

edt@bancobgn.com

by stngfan1

The JetDirect is external. IBM doesn't make Win95 drivers for this unit. They say use an HP LJ 4 driver. I've deleted the NW stuff and re-started. I've also hooked up a differnt printer to the same JetDirect and it has printed, without any problems. So I know NW is OK.

by lynbor

That's an interesting problem. Based on what you'd posted so far, I'm wondering if you might be having a memory shortage in your printer... Are you getting no errors on the printer or the print server?.. An error message would help point to somepossibilities. I'd also try dropping back to the HP LaserJet III driver which is the oldest and most compatible driver of the HP LaserJet series. Additional observation of the problem, like does it break only on large print jobs? Is your Novell Client set to AUTO END CAP in the Default Capture tab of the client properties? Is the Jet direct set to be a Bindery Que printer? (That's how I'd have it set) From what I've read, the 3916 is nearly the same as a 4039, so you might try using the drivers for the 4039 and see if that helps. But I'm stuck on the intermittant'ness and the fact that a different printer doesn't experience problems. That makes me feel that the problem lives with the printer itself or the print drivers rather than a problem with your network.

This discussion is closed to new replies.