Discussion Locked

IBM PC300GL rebooting problem...

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have two IBM PC 300GL Type: 6287, Model: 61U. Both of these machines within a period of 3-6 months after purchase, starting rebooting itself in Win98. You'll be working on a Excel spreadsheet (or any program) and it just reboots by itself unexpectedly. I've replaced the CPU, HD, DIMMs, Network cards, reformated the hd and re-install Win98 from scratch, etc., etc... nothing works. I know it's a motherboard problem. IBM will be sending me new motherboards replacements, but I just wanted to askyou folks if anyone of you have similar machines that does the same thing... or anything else to suggest?

8 replies

by mcorr

We are all blue but don't use that particular model here. We have 6282s, and if they are similar you might want to check the riser board. We have had several come in bad or fail after some use.

by tchieng

This model does not have a riser board. It just have one main board.

Thanks for your input.

by mphoffar

Only suggestion I can think of would be to disconnect the PC from the network, just to see if there is some sort of wake on lan kicking in.

Mark

by tchieng

Good thought, but the PC was also tested in stand-alone configuration with the network card out and still had the problem.

Sorry I ran out of points to give...

by tchieng

Nope! That's not it either. This board doesn't use that chip, but thanks for the input.

by ec364

I got some machines of the same model. One behaved exactly the same way as you got. After spending a lot of hours with the PC, I finally got the problem. It was a crack on the motherboard. The IBM tech confirmed it and said that a lot of machines with this model got the same problem. It's a fine hairline crack along the expansion slots. I guess the board is thin and brittle and damaged in the assembly.

by tchieng

That's what I though as well... a defect in the motherboard. Thanks for confirming my question.

This discussion is closed to new replies.