Discussion Locked

ICS-Internet Connection Sharing

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

-Read an interesting article last night on this site on this issue.Before venturing there,looking for some insights from fellow tech gurus---MY QUESTION----
THE INSTRUCTIONS SAY I HAVE TO HAVE WINN98 OR WIN2000 AS MY HOST.I HAVE AN NT SERVER W/1
WORKSTATION & 1 WIN98 PC ON MY HOME NET.MY DIAL UP HAS SERVER ASSIGNED IP ADDRESS ON MY SERVER.ANY INPUT AS TO MY NT4.0 SHARING WITH
WIN98.THE ARTICLE DID SAY CLIENTS CAN BE (WIN95,WIN,98 WINNT)--ANY HELP WITH CONFIGURATION WOULD BE MOST WELCOME--THANX-AZIZ--

8 replies

by calves

Sharing the article would be most helpful on understanding what you're trying to accomplish.

by azizhakim

THE URL IS
http:techrepublic.com/article,jhtml?id=r32000029rec01.htm.check it out.in closing e-mail with any thoughts,azizhakim@yahoo.com--THANX

by dc1

If you are going to use Nt 4 then you will need to also use PRoxy server. NT2000 and 98 both come with Internet Connection sharing software.

by azizhakim

THANX FOR INSIGHT,I DID ASSIGN NT AS MY PROXY SERVER,BUT DID NOT GO THROUGH.I WILL HAVE SOME READING TO DO & RECONFIGURE--THANX ONCE AGAIN

by Member 30576776

If I understand your Q, you are trying to use ICS on your win98 machine to share an internet connection with a WinNT machine. Use the ICS wizard to set up the win98 machine. It has now become the DHCP server for your home network. Configure the WinNT machine by adding TCP-IP to the protocol stack, change the properties so that the winNT machine will get its IP address dynamically. You might need to install the DHCP manager on the winNT machine and set the IP address of the win98 machine. Check the documentation to be sure. hhp

by azizhakim

THANX SO MUCH,I WILL GET STARTED,IN MY CASE I HAD MY DHCP MANAGER VICE VERSA.ONCE AGAIN ----THANX

by xaeryth

If you're NT Server is acting as a domain controller than you MUST make sure you have the IP address set to 192.168.0.2 (or higher) as DHCP can not be used on domain controller because they require static IPs. The IP address on the Win98 SECOND EDITION (ICS wasn't available in 1st) MUST be 192.168.0.1. Make sure the modem is connected to the Win98 machine and configured to dial your ISP. Have the NT Workstation (and NT Server if it's a member) use DHCP. When you set up the browser have it detect settings automatically and it should work. My biggest suggestion is to use Windows 2000 as it handles ICS MUCH better. In either case, if you run into problems follow the article found at this link (it helped me when I first started setting these up and I've now done around 50).

http://support.microsoft.com/support/kb/articles/Q238/1/35.asp

Hope this helps,

Corey Hitchcock, MCSE
IT Manager
Interdev Technologies Inc.

by azizhakim

THANX SO MUCH--EXCELLENT INSIGHT.FOR A BEGINNER THIS WEEKEND WILL BE OCCUPIED-THANX ONCE AGAIN--AZIZ

This discussion is closed to new replies.