Discussion Locked

Illegal Operation error messages!

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We have a small network of 80 end-users on a Windows NT server. Some of our newest computers are Compaq Deskpro en types. We utilize MS Office 2000 from our server to the end-users. Ever since enabled the energy saver settings on these computers,we get aggravating Illegal Operation messages, interrupting processes on the computers. In the details section, it says the general protection fault was in module "User.exe" Then gives the registers stacks that pertain to the error. Anyone have any suggestions? we are mandated by the State of California to use those energy setting at this time. (We are a small state agency). Can anyone even steer me in the right direction to even research an answer? Please Help?

Thanks to anyone -- Karen Weis, Sacramento, CA

4 replies

by k_e_weis

After reading my question, I needed to say also that although our ser OS is Windows NT 4.0, our workstations are Windows 95 & 98.

by dcassat

I know how much of a problem this is but I usually disable the power savers for all the problems I have had. Since that is not your choice I recommend that you go to Microsoft.com and search the knowlege base for power management. There are a number of articles and troubleshooting processes that should help you. In addition, on Windows 98 machines run msconfig at the Run prompt and disable all startup programs (except the power mgmt drivers). This troubleshooting may lead you to a driver that is causing conflicts with power mgmt. Best Wishes.

This discussion is closed to new replies.