Discussion Locked

install / configure interface

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm newbie in linux but i've some experience in netware and nt.. i found a problem in my linux server . there are two card in that server. eth0 was configured but eth1 was not. i'v try to use ifconfig to give ipaddr to eth1. that was success !!. but that was not permanent. if i restart my server, configuration for eth1 disppear..
maybe i must put the configuration in a file.
but i don't know what file is that.
please , i need some explanation for the problem
thank's

5 replies

by bengels

Which distro are you using? In SuSE you have to edit /etc/rc.config to make settings permanent, in Debian and RH it's some file in /etc/network/, if I remember correctly.

by techdictator

You should either change the point value of this question or open a new question and close this one.

This discussion is closed to new replies.