Installation of Linux
I have a 17 GB Hard Drive . I want to install Linux & WIndows both.
I want the partition details of how can i use both the OS on my system
My system is a P-III 550 with 64 MB Ram & 17 GB Hdd.
Linux
I have a 17 GB Hard Drive . I want to install Linux & WIndows both.
I want the partition details of how can i use both the OS on my system
My system is a P-III 550 with 64 MB Ram & 17 GB Hdd.
by mckaytech
I would install Windows first but the technique will vary a little depending on whether it is Windows95/98 or WindowsNT. Either way, what you'll want to do (either through Fdisk or the NT install program) is create a partition or partitions that take up only about half the drive. Install Windows on that partition, get it running nicely, etc.
Then run the Linux install program. There is a little variation from distribution to distribution, but most will make Linux partitions out of any uncommitted space on the drive. In the process, they will also write a new MBR (master boot record) that will allow you to choose whether to boot into Windows or Linux (generally using a program called LILO).
On my dual-boot Win98/Linux machine, I ended up with four partitions. A Win98 partition, a Linux root partition, Linux swap partition and Linux /var partition. When I boot up, if I want Linux I just let it run. If I want Win98, I hit [tab] when I see the LILO prompt, choose (or enter) Win98 and it boots int
by moiz_aziz
by mutated
by moiz_aziz
by jpereira
If it's Win9x, your first partition must be a Windows partition.
Some older versions of the BIOS have an issue with booting from partitions which extend beyond 1024 cylinders, so your Linux boot partition should be below that. You boot partition need be no larger than 16Mb.
You will also need a Linux swap partition which the rule of thumb says should be twice the size of your physical RAM - so 128Mb for you. You get a slight performance gain if it is in the middle of the disk.
You will alsoneed other Linux partitions including at least a root partition + you can have other Win partitions.
Here's how I'd do it on your PC:
1. Install Windows in a partition at the bottom of the disk making sure the top of the partition is enough under 1024 cylinders to fit in a 12Mb Linux partition (fdisk will tell you how many cylinders you have used).
2. Install Linux with the following partitions in the same order
- 12Mb Linux ext2 partition mounted on /boot
- 128Mb Linux swap partition- x Linux ext2 parti
by moiz_aziz
by skiz
Well if I were setting it up.
Install win98 to the HDD first... then use partition magic to resize the FAT32 partition to about 4 - 5 GB.
after you setup windows boot up the linux distro CDROM that you have.
I would make these partitions.
/boot 10 - 20MB
/ 85 - 150MB
/var 85 - 100MB
/home 400MB - 1GB
/usr 1.5 - 3GB
/usr/local remainder(i store mp3s, games here.)
I give me a directory in /usr/local/
so that I have ownership of the DIR as a user and store mega stuff there.
lilo should install clean in the MBR and you can dual boot with it. I have had good luck wiht both lilo and grub.
good luck and enjoy the new OS
by moiz_aziz
This discussion is closed to new replies.
Sort by Trending