Installing 95 on a older pc
I am having trouble getting the cd rom drive to be recognized in an older computer that is running windows 95. It isn't an option in CMOS, I do have drivers for it. This is very frustrating.
Do you have any solutions?
Desktop
I am having trouble getting the cd rom drive to be recognized in an older computer that is running windows 95. It isn't an option in CMOS, I do have drivers for it. This is very frustrating.
Do you have any solutions?
by jabend
If Windows 95 is already installed on the PC, and your CD-ROM is not available, I have had success installing the DOS drivers for the CD-ROM in the CONFIG.SYS and AUTOEXEC.BAT files, as if it was a DOS or Win 3.x workstation. Make sure you assign adrive letter to it.
When Win 95 starts, it should then have reference to the CD-ROM. You may not get the best performance out of the drive, but you will be able to use it.
If it is a new installation of Win95, also make the necessary changes to the CONFIG and AUTOEXEC files, re-boot to DOS on the workstation and run the WIN95 installation from the CD.
Good Luck!
by dehavenanne
by zalog
You will need to add the driver file assignments to the config.sys and autoexec.bat files of your boot disk. The config.sys will have a line like:
DEVICE=cddriver.SYS /D:MSCD001
Where cddriver is the name of the device driver file.
The autoexec.bat will have a line like:
MSCDEX /D:MSCD001 /V
You will need the device driver file and the MSCDEX.EXE file on your bootable disk.
by dehavenanne
by mphoffar
How old is older?? Only that comes to mind is if this is a Intel TX chipset on here, you'll need to get the INF patch from Intel's sit. There'sa link directory to that on www.windrivers.com (under bus mastering)
The other thing to look for it to use regedit and go to
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\VxD\IOS
There may be a noide value in there, just remove that entry and reboot. After you reboot, windows should try to initialize the controller again.
Hope this helps..
Mark
by dehavenanne
by user11474
The easiest way around this problem is to find a Windows 98 bootdisk! With a 98 bootdisk you have the option to start the computer with CDROM support. Choose this option the change to the drive letter it assigns for your CDROM (probably E: as it usually assigns D: as a virtual drive) type setup and you can then install Win 95 with no problems.
Hope this helps.
by dehavenanne
by bucko77
If W95 can't even see it, it's probably not switched on. Make sure you have enabled your Secondary IDE channel in the BIOS.
If you are running it on the same IDE channel as your hard drive, make sure you have it jumpered as a Slave (the CD-Romthat is)
by dehavenanne
by dehavenanne
This discussion is closed to new replies.
Sort by Trending