10 replies
I would remove anything that is not required, i.e., remove all cards that plug into the motherboard other than the video card. Then try to install, I've had trouble when trying to install everything at one time. If it still locks up, remove some of the memory (if it's not all on one stick), you may have a bad memory stick.
Don
by mdavis
by stillatit
Take a look at the hard drive, and make sure that if it is ATA-100 that your motherboard can handle it and that you are using the new ATA-100 cables. Make sure it is on the hardware compatibility list.
If you are using any special utilities on the hard drive for formatting and/or partitioning, re-read the manuals on these and look for W98 install instructions.
Good luck.
by mdavis
by mm212
by mdavis
by mdavis
Trying new memory may sometimes work and sometimes not. Did you try an exact duplicate. If so, there may be your problem. Certain memory (manufacturers) strips will conflict with certain boards. Also, check the speed of the memory. With a 1.3 AMD, your memory must be 133. Memory is backwards compatible, but not forward. Inotherwords, you can put a stick of 133 into a 100 slot, but a 100 will not work in a 133. I was taught this lesson the hardway. If possible, just swap your strip for one of another brand. Win98 will install on 32 megs of memory. I suggest Kingston or PNY. I have had problems out of Crucial and (I cannot remember)the brand that Circuit City sells.
Also, if your memory is malfunctioning, the AGP card will notboot.
Paul.
by mdavis
by mdavis
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending