Discussion Locked

Installing External Drive

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do you install a external drive to NT?

6 replies

by arwjnplanotx

If you are talking about an IDE drive I wouldn't recommend it. There may be ways to do it but it is definitely not standard.

If you have SCSI of course you'll have to have a SCSI controller, either built into the motherboard or on an adapter. Youwill then need a SCSI hard drive, an external SCSI cable and an external SCSI box to hold the drive. If you have other SCSI devices, you need to set the box (or the drive) unit number different than the other devices. On a standard SCSI controller you can use device numbers 0 through 6. On an ultrawide controller you can also use 8 through 15. If you need more help come back here or you may be able to find information about SCSI interfaces on the web.

Good luck,

Al

by lewey04

What kind of external drive are you talking about? Most external drives are SCSI which means you need a SCSI card, cable and a terminator. Make sure that you have termination on both ends of your SCSI chain. Good luck.

If the drive is USB or parallel port then you may be in for a ride with NT. I have installed an external CD-Rom drive that was a parallel port drive. All I had to do was get the drivers from the manufacturer.

This discussion is closed to new replies.