8 replies
by mphoffar
Sounds like you got an intel chipset on your board. What you need to do first is get the PCI Bridge Fix & INF Updater from Intel's site.
http://developer.intel.com/design/software/drivers/platform/440.htm
and run that. After rebooting you'll go through a bunch of new hardware found. When it's all done (and a few reboots) your CD-Rom should be recognized through windows, as should be the PCI bridge i nthe right place.
Best luck I've had with the 906 nics has been to leave it at PCI Ethernet card and then update the driver in the control panel.
Good kuck to you
Mark
by seadogs
by dlucas
by seadogs
by rogueldr
I would install win 95 without the NIC card in. Install the NIC after a sucessful win 95 install. I've had many problems with win 95 installing correctly with NIC, esp 3com's.
The reason that the CD-Rom problem happens is because when you installwin 95 you have a bootdisk with a CD-Rom driver on it. When you reboot it's booting from the C: drive which does not have a CD-Rom driver loaded. Sometimes if it is plug and pray win 95 will find it on your second boot up which is a pain in the butt. I have found that if you have the device defined in the config.sys file prior to boot and the appropriate .sys file for the CD-Rom on C:\ that win 95 will find it and load a driver for it.
DEVICE=D011V110.SYS /D:OEMCD001
In the example above D011V110.sys would be on C:
There are many universal CD-Rom drivers out there that will spin up most CD-Rom drives. You could also use the one from your boot disk since it successfully used the CD-Rom for your install of win 95.
by seadogs
by seadogs
by seadogs
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending