Discussion Locked

Installing NT Server 4 as BDC

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying to NT Server 4.0 onto a new server as a BDC. The PDC is active and working, but when I get to the screen where I have to specify the domain and NT Username and password, it will not find the domain. Is there another way I should have done this.

3 replies

by todd

You MUST make sure that the computer you are installing NT on is connected to the network, functioning network card, has an appropriate IP address, and matching subnet mask, so that it can find the PDC during install.

by jason

I have done that, and still cannot find the PDC, iam using static ip's should that make a difference

by ckaylam

I think the problem mostly related to the connection problem.(Assume your PDC have only lan card)

Please check the cable , Lan card in other system to make sure that it is in good condition.

Let me know any improvement if you like
Then connect the BDC to PDC using the Direct Cable (cable for connecting Hub to Hub )

Attention. Please also make sure that You are using the Administrator Password of PDC

This discussion is closed to new replies.