Discussion Locked

Internet access in WAN environment

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm trying to setup internet access for a New York office. Our main office is in Dallas (using TCP/IP scheme 192.168.90.xxx) which is connected to the internet via a Cisco router with NAT enabled. Currently, our New York office (192.168.100.xxx) comes down a Frame Relay pipe and out our Cisco router to get to the internet. I want to setup a router in New York so that users there don't have to come down to our network to get to the internet. I setup a router and made it the default gateway on a workstation there, but it can't find it. Any suggestions?

2 replies

by rpatch

I had the same problem and found that my router configuration was wrong. My router did not know about the other network. Hope that helps.

by jj

There's not a lot to go on from your msg, but here goes :

If the your are using a different interface on the same router in NY (one route to Dallas, one to the 'net), you must make the new interface to the 'net "more attractive" to IP traffic. This varies depending on what protocol you're using - but RIP should figure this out automatically. Alternatively, set up a default route.

Assuming that you still need some IP access to Dallas resources, you would also need an access - list to point any packets destined for Dallas to the Dallas Frame Relay circuit/interface or more specifically 192.168.90.[your dallas router's ip address]

thats my best shot. if someone wants to add meat to 'dem bare bones - go ahead.

jason

This discussion is closed to new replies.