Discussion Locked

Internet access in WAN environment

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm trying to setup internet access for a New York office. Our main office is in Dallas (using TCP/IP scheme 192.168.90.xxx) which is connected to the internet via a Cisco router with NAT enabled. Currently, our New York office (192.168.100.xxx) comes down a Frame Relay pipe and out our Cisco router to get to the internet. I want to setup a router in New York so that users there don't have to come down to our network to get to the internet. I setup a router and made it the default gateway on a workstation there, but it can't find it. Any suggestions?

7 replies

by bcross

Can you ping the router? Are you using DHCP? If so, where is the DHCP info coming from? A BDC in NY or the PDC in Dallas? If you're using DHCP, don't forget to configure the router in the DHCP configuration. I assume you're keeping it simple though... if you can ping the router on you're LAN, can you ping it from the internet? If not, there's you're problem.

by dheupel

Not only follow Brandon's suggestions, but you must also make sure your workstations are pointing to the new Cisco router as the default gateway, or their packets will not cross the router.

by blair.mcfarlain

Both previous suggestions are very good. Do what they say.

Also, what are you using for workstations? If you are using NT, you can have up to three default gateways (and have them all work), however, in Win 9x, you CAN add 3 default gateways, but windows will only USE one of them. (the first one I think). Its a documented problem with the microsoft client that the have never fixed to my knowledge.

If you want a win9x workstation to see both as a gateway, you will have to set a gatewayfor one, then add a route for the other(s)

I had this problem in our baltimore office where they had a local box for internet. It was essentially a router, (with no proxy) and all users needed to access it. I could set two default gateways on the NT machines, and they worked fine, but the 9x machines had to have that default gateway (to internet), and a route to tell it how to get to our frame network back to our corp. office.

Anyway, hope this helps!

This discussion is closed to new replies.