All the Spy Ware/Mal Ware Scans work better in [b]Safe Mode[/b] and here I do mean [b]Safe Mode [u]Not[/u] Safe Mode With Networking![/b]
If you ran the Scans in Safe Mode you are far more likely to be able to remove problem files and when they can not be removed because they have been loaded into RAM the software will ask to run a scan on the next reboot and scan the system before anything gets loaded. I also tell all my clients to keep running the scans till they come up as clean as I've seen examples of computers that haven't been scanned for ages requiring up to 7 scans to totally clean out all of the infections by just 1 piece of software. Then I move on to another Piece of Software and do it all again.
Now I take it that this isn't affecting all the computers at the same time so you need to look at the individual computers but if it is affecting everything at once the place to look would be the Modem & Switch with the Switch being my first suspect.
As this is killing off parts of the Windows Kernel you really need to look for infections bad loads or load errors that occur all the time when new software is installed. Normally these will not present a problem but when you get the right mix of load errors with the wrong links or file shortcuts this can cause problems and though it generally only happens on computers running specialised software it's still possible and some kind of third party Software Checking Utility is needed to check for software errors. I've found up to 350 errors on a clean install of a simple XP Pro Office XP Pro and the utilities that are required to keep the system running without infection and so forth.
I've used Norton's System Doctor in the past to cleanup Load Errors in Windows but even that fails to fix problems when the .Net 3 framework is installed as that just points to things that do not exist.
The other thing to look at is the actual incoming mains power as a 3 to 5 hour time between failures doesn't look like a normal fault there could be a hardware relation helping to cause this as well.
So start off with the obvious is there plenty of clear space behind the Towers to allow hot air to escape and not be sucked in again?
Are the cases far enough off the ground so as not to suck in lots of dust and other rubbish and cause shorts to occur randomly?
Have you actually opened a case to see how clean it is?
Are all of these computers and the Modem & Switch on the same power circuit or are they on different ones?
Do you have any heavy Industry around where these computers are that could place a large power drain when they start up?
Lets know the answers to these questions and we'll see where things go from there.
Col