Discussion Locked

Internet sharing with NT Server an '98?

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an NT server connected to the internet with a DSL modem. I have a '98 machine that logs into the NT server. Internet connection is fine on the server but it doesn't work on the '98 machine. Must I use a proxy server or can I set up the theserver's ethernet card's IP as a default gateway on the '98? I am using DHCP for the servers client(s) (soon to be more than one '98 machine). If I can use the server as a default gateway how do I set it up in DHCP config manager?

E-mail me if you need more info.

T_Buck@email.com

8 replies

by kevin brown

Unless your ISP provided you with more than one valid Ip address, you will have to use some form of NAT.

Proxy server will work for you or a DSL router/modem that has NAT built in.

by Former member

You can use it as a default gateway as long as the server and clients are on the same subnet, ie..
Server: 132.42.55.1 Client: 132.42.55.2 (subnetted class C)

And these addresses must of course be internet addresses and not internal, made up addresses. You'll need a proxy or NAT/PAT server if they are not...

In DHCP, you have a scope of address, which may require at least 8 or 16 minimal addresses. In you DHCP admin., under DHCP options, scope properties, you can add the '003 router' option and add the IP address of your Server in the properties. You should also add the ISP DNS servers here as well.

by Former member

Forgot to mention that there should be some routing enabled on the server between the DSL MOdem and the NT Server ethernet card. Enable IP forwarding.

by mdeyette

More specifically, some options for you to run NAT would be SyGate, NAT32, or NAT through something like FW1. I believe LinkSys has a home use router/hub that has a built in DHCP server and will do your NAT for you so your NT server isn't your gateway.

Email me if you want me to get more specific. The guys ahead of me are correct, just not specific enough to be of help.

This discussion is closed to new replies.