Discussion Locked

Intranet & Internet connectivity

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have established an intranet with now 6 computers on it. It will be more in the near future. I had cable modem installed and the RJ-45 was put into the switch. Before doing this every computer was able to be seen on the network. How can I resolve this problem.... It was suggested that I set up a second nic into each machine that I want to go to the internet and the other nic for the intranet. This to me sounds like an expensive work around. The 2nd suggestion was to install a gateway in between the cable modem and the switch. What would you suggest??? I am going to have to go to work later today to resolve this problem. Its now 10:30am.

7 replies

by awong

i am not sure if you are heading the right direction with your solutions, have you check to see if your newly installed cable modem have dhcp build in. and if your computers do not have obtains ip address set up, you will not see anything from your network neighorhood.

by timthetoolman

Hi,

I know this answer is a couple of days late...but...

Adding a second nic into your server will probably cost you less than you think - maybe $10-$20

If you do this, you'll be setting up the server to be an Internet Connection Sharing machine and that'll be perfectly acceptable for 6 pcs. ICS can support 255 machines in total but I dont know how performance goes when you get that many on the network.

An alternative you have is to install a router between the modem and the rest ofthe network that is capable of doing NAT. This is essentially the same as the above setup except that the router does the work that the multi-homed (two nic) machine was going to do.

Its also a lot more expensive.

Also there is the consideration that the PC with two nics will need to be up for conectivity.

Either way will work fine for you but the dollars are different.

Cheers,
Tim

by pan 13 x

go and get a 4 port cable modem router and connect it the the cable modem. Connect the two other primary computer directly to the router. Now you should already have a switch/hub connect the uplink cable to the last port on the router. cannect the rest of your netork there and you hsould be rolling. You can use this router to preform nat/dhcp/and dns forwarding. I am running 12 computers in this configuration and this hasn't missed a beat.

This discussion is closed to new replies.