Networks

Ask something
Question Locked

IOS 12.2 switching vlan question

0 helpful
2 replies

by selltekk 1 view

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

It's been a good ling while since I've done this so I am very rusty.

I need to configure one (or all) ports on a cisco catalyst 3560 to be on a VLAN.

Am I correct in assuming that this would be the correct set of commands?

conf t
int vlan ####
ip address x.x.x.x x.x.x.x
no ip route-cache
no shutdown
end
conf t
int range fa 0/1-8
switchport access vlan ####
spanning-tree portfast
end
conf t
int gi 0/1
switchport trunk encapsulation dot1q
switchport trunk native vlan ####
switchport mode trunk
switchport nonegotiate
end

Provided that the encapsulation on the other end of the gig port is 802.1q, should this work?

2 replies

by selltekk

It turns out that the problem was with the wireless link between switches. There was no trunk. Having spanning-tree bpduguard filtering off was hosing the rest of my ports. turning on the filter brought them back up and restored the port type consistency.

This discussion is closed to new replies.