Discussion Locked

Is there a 24 pin power supply?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm building a server for a law firm and I purchased the Intel server board STL2 w/dual PIII 1Ghz. The board's main power connector is for a 24 pins male connector, with an additional power supply signal connector for a 10 pin male connector. I have not been able to find such an ATX Power supply. Can anyone advise.
Thank You

7 replies

by thechas

It seams that the STL2 does not use an ATX type power supply. Intel has set up there server boards to require a different style power supply.

Check out http://www.intel.com/go/serverbuilder

All the good stuff requires you to join their partners program.

You can however download basic data sheets.

The Data Sheet for the recomended server chassis uses a PFC power supply

by aiavive

I tried all of the above, and they do require one to join and wait for approval.
I will try to use the regular ATX power supply, any comments?

by thechas

By definition, an ATX power supply has a 20 pin mother board connector. To have a different connector would make it something other than an ATX.

Some of the newer ATX supplies have 2 additional connectors.
A 4 pin 12 volt connector, and a 6 pinauxillary power connector.

by csmith

This sounds like you are trying to jury rig in a cheap power supply, so here goes.
Match Pin 1 to Pin 1 of The MB and PS connectors.
Plug in. Pray. Turn On Power.

Better, make an adapter cable. the color codes are standard, so it is no big deal.
See page 5-68 in the MB Manual.
If you do do not have the manual for the STL2, it is at ftp://download.intel.com/support/motherboards/server/stl2/stl2_tps.pdf
The reason for the extra pins is to carry the extra current necessary for these dual CPU boards. Remember you loose this safety with jury rigging.

Now the proper way.
Buy a Turbo 475-ID power supply from PC Power and Cooling.
This power supply is built for the STL2 family.

The number for PC Power and Cooling is 800 722-6555.
Their website is www.pcpowerandcooling.com
Look under power supplies for dual CPUs.

PC Power and Cooling builds some of of the best power supplies made.
They are very reliable, more expensive, and more than worth it, if your reputation as a builder is important.
We use them on all of our middle and high end builds.
Regards, Chris

by csmith

:
Now the practical side,

Besides the Turbo475-ID being a no brainer,
(Just plug it in to the motherboard), the fault protection circuitry of the PC Power and Cooling power supplies works properly.
This means, that we can allow fairly new technicians to help build a midrange PC such as this.
Even if they short something out, the power supply, promptly and properly, shuts down, then they must pull the plug from the wall, they remove the short, and power back up. Usually with no damage.
This means you do not experience the smell of burned electronics.
This is in contrast to the power supplies from communist China.
They register a design in the U.S. , but then they leave out components in the products they ship, to save money. This leads to smoke and smell, when something goes the least bit wrong.

If you are building this system, in house, don't forget to segment the LAN to take advantage of the I/O capacity of the STL2 motherboard.

If you are getting into building dual CPU PCs, you have the correct motherboard for this application, but when you build workstations for Photo editing, or design (AutoCad, ProE, etc.),
check out the Tyan-AMD Athlon dual CPU setup. (The math unit in the Athlon is better than the Pentiums, and thus you get better performance for these applications.)

Regards, Chris

This discussion is closed to new replies.