Discussion Locked

ISDN WAN

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 2 Cisco 775M ISDN Routers, in two locations. I'm trying to set up a PtP connection between these two. I've gone through the examples on Cisco's site, gone through the manuals, and countless other things trying to get these two to talk to eachother. But either the dialing router can't reach the server router, or the dialing router get's disconnected shortly saying that the password has been denied (and both routers are set up with the same passwords.) Anyone else have this problem?

10 replies

by stillatit

It is often the case that one or more carriers in your route cannot handle 64K clear channel signalling. Try knocking both routers back to use a 56K connection. Also, for debugging purposes, tell both routers to use only one channel.

Presumably you have the correct SPID's in each router, and have the routers dialing 11 digits (1+area code+7).

Other things to check: I believe the Cisco's allow different flavors of authentication. If so, make sure they are using the same one. If there are variable encryption levels they need to be the same also.

Good luck.

by Former member

Your question is much too vague to be even remotely answered. Your entire configuration has to be combed through. I suggest you start with the Cisco TAC.

by barry hensley

Assuming that you have ISDN setup properly on both routers, including encapsulated PPP on both interfaces, and have both ends set to either PAP or CHAP, and have the proper case for the login (CHAP is case sensitive), then you should use Cisco's debugging tools to find out what is going on.

Try "debug isdn q931" to see if there is something wrong at the link layer.

Also try "debug ppp auth" to see if you are having authentication problems.

by lomex

Check out PPP authentication.
Try removing password encryption.
Try removing the password first.

This discussion is closed to new replies.