Discussion Locked

Kixtart Will Not run a batch file...Help

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Below is a copy of a basic login script:

? @USERId

? "Please wait while your logon script runs"

? shell '%Comspec% /c wshbat' <<<

9 replies

by adoran

Point value changed by question poster.

I really need an answer on this guys..

by mphoffar

Sounds like you need to map your drive in a normal batch file using
net use : \\server\share
and then call your script a the end of it.

we had a lot of headaches running kix scripts here in 95 and 98

Good luck to you

Mark

by adoran

Mark....Very close, but not exactly what I'm trying to do. Maybe what I intend to do cannot be done, but here goes:

rather than using a specific server to run the script, which would mean a couple of hundred clients hitting a server over a LAN & WAN, I need the Win95 clients to run the script from the validating server - i.e. there are BDC's in the various area's of the group & I would like these server's to run the script, not just one particular server.

If the above seems confusing, plsmail me & I'll try to explain further.

by netwill

What I did is use @lserver.

$NDS=@lserver+"\nds"
run "net use n: $NDS /yes"

That works for all NT, Win9x.

by juandemarco

I recently had a like problem in a VA hospital, and this is what I did to fix it. Kix32 has the ability to check valadating servers. Therefore, I used the command in a URL in running my batch file. This looked something like this:

\\@LSERVER\netlogon\inst.bat

You said that you tried @LSERVER but I don't know if you tried this. Hope this works.

This discussion is closed to new replies.