Discussion Locked

LAN testing

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I would like to test our new LAN. Could you please provide me the tips regarding to that testing. What I mean here is how to test the connectivity for all the equipments in that LAN including the physical parts.

9 replies

by fabiano pacheco

The complete test (and it is used to certify a cabling) is using an equipment called Penta Scanner. It?s tests all parts of cabling from impedance to cable?s lenght.

by fendi86

Your answer didn't help me at all. What i am expect from the answer is the procedure to test the LAN (step by step)connection. Could you please advice me on that matters.

by gpwruck

To test network cabling you will need to buy or rent test equipment. The Penta Scanner is one of the best available. It?s tests cabling completely and does ether net login checks also. Without some kind of test equipment you cannot check the cables, jacks, and/or plugs. The Penta Scanner is very easy to use and comes with a manual that explains how to perform all the tests. My suggestion to you is to rent test equipment or hire someone to test them for you.

by dlw6

There are several ways to do this, but the best approach is to do the easy tests first to narrow down the problem.

In preparation, get an accurate LAN diagram that shows how everything is connected and the IP addresses (or equivalent for whateverprotocol you're running).

Start with a connectivity test, such as PING. Use the LEDs on the network cards, hubs, switches, and routers to watch for traffic while your PING is running.

If the PING fails, you can use TRACERT (Winxx) or TRACE (Cisco) to determine where the path has failed. Recommend you use the " -d" switch to speed it up.

From there, you can start testing the node that failed the trace and/or the cables on both sides of the failed node.

Testing a PC, hub, router, etc. will vary based on what it is. You can start by determining which machines can talk to each other, to narrow down the problem.

Testing cables requires testing equipment such as the COMPAS or some lesser tester.

That's all I can tell you without more info.

Good fortune,
Don

This discussion is closed to new replies.