2 replies
by wenfromiu Accepted solution
by older mycroft Accepted solution
The space below a laptop keyboard, AND for that matter - a desktop keyboard also, consists of layers of translucent plastic, held apart by a layer of similar plastic with holes punched in it corresponding to the placement of each key.
The top layer has a printed circuit on its lower face, the bottom layer has a printed circuit on its upper face. The actions of the keys push little nipples into their respective holes making a momentary contact between the upper and lower printed circuits.
Consequently any spillage of water - no matter how small you may think it to be, will spread between these layers of plastic to varying degrees, causing 'shorts' and 'burns' wherever the contacts got wet.
Removal of the keyboard from the laptop is usually the best bet. Placement in a warm area like an airing cupboard might work over a couple of days. However, these printed circuits terminate in a single chip that reads the input from the keyboard and if it has shorted out, the keyboard is usually beyond repair.
If there was anything sticky in the liquid, like sugar, the damage is even worse - you might be able to dry it out but the sticky stuff will remain between the plastic layers.
When you are experiencing odd letter combinations as you type, that is due to other data lines in the circuit plastic making contact due to water intrusion.
I wish you the best of luck in drying it out, but water and keyboards really don't mix.
This discussion is closed to new replies.
Trending Tablets posts
Sort by Trending