Question Locked

Laptop-style Battery to Desktop Motherboard

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm working on a project, and I need to connect a laptop style battery or similar battery to a desktop motherboard, and be able to charge it in the normal laptop way (plugging in the AC cord). Does anybody know of a way to accomplish this? The battery DOES NOT have to be removable for this project, just rechargable and able to run a small desktop computer (~300-400watts). I don't think a small backup power supply would really suit this, as it has to be used to power the system and be recharged on a daily basis. Any thoughts??

11 replies

by older mycroft

You seem to be under the impression that the only difference here will be the power source - WRONG!

For a start, the laptop AC connector plugs into the motherboard which then channels the charge to the battery. This type of circuit doesn't exist on a desktop motherboard.

Next, laptops tend to use low voltage components including the CPU which is invariably a 'mobile' version of a desktop CPU, so it draws less current and the battery power lasts longer. This will not be the case with a desktop motherboard.

Also, a desktop motherboard draws current at various sockets on the motherboard, on at least 3 different power rails (3.3V, 5.0V, 12.0V) controlled directly from the PSU. Without the laptop motherboard circuitry to deliver power, I fail to see how you could possibly achieve this directly from an unregulated battery-power source.

As for a 300 to 400 WATT power supply, my Acer NB battery carries 14.8V @ 4000mAH which only equals 32 WATTS. A desktop PSU has to be able to perform on 110/220V.

by normh3

As mentioned, this will be impossible to do. Perhaps if you explain what the project is, other suggestions could be made.

by oh smeg

You may as well start off with a Car Battery at least that Has 12 V DC Available unlike the NB Battery which only has 5 V DC available.

Nothing in a NB requires more than 5 V DC where as a HDD or Optical Drive in a Desktop runs on 12 V DC. So It's not possible to use a NB Battery to run a Desktop.

If you chose to use a Sealed Lead Acid type Battery you would need to drop the Power to some circuits to 5 V DC and 1.5 V DC and build some kind of Battery Charger into the case. Either way it would be horrendously complex and not likely to be overly stable.

Col

by dixon

...imagining what this project is about, other than that it sounds like it involves a location without power. Is there a reason that you can't just use a laptop to do whatever you're trying to do?

by oh smeg

With a Wind or Solar 12 V Battery Charger would be the better way to go but a NB would be cheaper by a large amount of money.

Col

by normh3

There are, or use to be, labtops available that would accept 2 batteries for longer use.

by jjrichey

Alright, thanks guys. I figured it probably wouldn't work, just thought I'd throw it out there and see. SO I probably couldn't find a UPS powerful enough for the use.

by oh smeg

That they are not terribly efficient at inverting to Mains Power.

You are not just connecting a Battery and running the computer from a battery you are connecting a battery to an Inverter and running the system off the Inverter and then using the standard PS to break down the power again to what the internal components require.

However it is possible to run a Desktop Computer off an Inverter. You just need to have enough Battery Capacity to keep the computer running and some sort of Safety Device to stop the Inverter when the Battery gets low.

Col

by oh smeg

You still need a way to recharge the batteries in a timely manner.

Col

This discussion is closed to new replies.