Discussion Locked
0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Our TIS department supports 20 Toshiba Satellite 220CD laptops. We purchased some New Media Tech. LanSurfer 56k 10/100 PCMCIA Fast Ethernet + Modem cards. We can see the network just fine with these cards but we can't use the dial-up networking. The modem installed automatically on COM2 (default setting) but the dial-up can't find it because it is looking at COM1. Is there a way to make it see COM2 or install it on COM1?
9 replies
by zlitocook
I have seen this on desk top computers where we use the OEM drivers for the modem and it will only install on the port they pick. Did you contact the OEM with the problem? We did and recieved a new driver that installed on the port we needed. Is themodem part softset? I mean can you change it with the software or is there jumpers on the card you can change? What is using com two if anything, you can assign ports to what you need to.
by cabarrus
The question was auto-closed by TechRepublic
by bv2
If the dial-up is looking at COM1, delete the dial-up and create new one choosing the modem on COM2. Dial-up Networking picks modems, not ports.
by cabarrus
The question was auto-closed by TechRepublic
by grantcom
No. 2 has it correct. When you go to diagnostics under "Modem" in control panel does the diagnostic come back with info on the modem? Are there modems that have been removed still listed under modems...if so remove them. To direct the Dial up conectoid to the proper port right click the conectoid and go to properties and select the proper modem...this should direct it to the proper port.
by cabarrus
The question was auto-closed by TechRepublic
by samsarijan
Your problem is simple. All you have got to do is go into the CMOS Bios and change COM1 to COM2 and COM2 to COM1 in the integrated Peripherals. Example to do this, is to swap Onboard Serial Port1 to Onboard Serial Port2 by swapping the IRQ/3F8 and IRQ/2F8 aand vice-versa
Believe me it works!.
by cabarrus
The question was auto-closed by TechRepublic
by cabarrus
This question was auto closed due to inactivity
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
0 helpful
1 reply
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies