Question Locked

Limited or no connectivity. Cannot get an IP address

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

First here some spec.
Laptop Acer Aspire 1640
Onboeard wireless
Windows XP SP2
Router Linksys WRT54G
Wep inscription

When I try to connect my laptop I see my router and connect to it but it cannot get an IP address so I end up with a limited connection.

Thing I try:
Run Wisockxpfix.....problem remain
Reset Router (unplug/replug)... no result
check WEP key (copy paste it so no mistake)
run configip /all in promtp
run netsh winsock reset in promtp
other PC directly plug in router and working (using one at the moment)
DHCP on auto

So what did I miss My laptop use to work fine before don't know what else to look
thanks,
Maltz

6 replies

by mike barron

I have had this problem with a few of the laptops in our domain.

If all the settings are correct (DHCP, WPA, etc.), I uninstall the wireless card through device manager then restart the pc and let windows redetect the device and reinstall the drivers.

This has worked in most cases unless the wireless card was bad.

I would also recommend upgrading to the latest wireless drivers.

by older mycroft

Is just as bad as it appeared in this post ?

Try it all again. ;)

by maltz007

I have install the latest driver yesterday still limited connection.
install XP SP3 as well problem remain.

the command line work when I type it I just didn't write it properly in the post english not my native tongue.

so I still can't get an ip from the router

by mike barron

Try a static IP address instead of using DHCP. maybe there is an issue with your router.

by larryd4

Could you actually be out of usable addresses?

How was DHCP config'd on the router?

This discussion is closed to new replies.