Question Locked

Linksys WiFi Adapter Causes Windows to Ask for Password

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Installed a Linksys WUSB54GC wireless G USB adapter on a desktop using Windows XP Home.

After installing, Windows asks for a password to log-on when I did not program in any password. None of the password clearing applications solves the problem.

when I uninstalled the Linsys, system was back to normal.

Any ideas what to do to avoid this condition?

4 replies

by thumbsup2

Did you read the installation instructions for the Linksys? Are you sure it's not asking for the password to the Linksys? If not and it indeed is asking for Windows password, the Linksys installation may have attempted to set up a home network which would require logging in to Windows. If you didn't set a password, try just pressing enter or clicking ok leaving the password blank.

by gyreyes

It is not Linksys asking for the password. The password screen comes on even before Windows has fully booted up.

Trying to simply press Enter without entering anything in the password box just results in a rebooting of the PC and then the password screen again.

by gyreyes

Consulted Microsoft about Windows suddenly asking for password on log-on. This worked for me and might for others with a similar problem.

Here is Microsoft's suggestion. Note that this works for when you are installing the Linksys WiFi adapter WUSG54GC:

1. First uninstall the software for the Linksys adapter in add/remove programs.

2. Leave the Wireless adapter plugged.

3. Put Linksys install disk in and when installer starts click setup. This will install a few files, which it is actually installing the adapter drivers.

4. Another window will popup that says next or continue...DO NOT CLICK THIS.

5. Click CTRL/ALT/DELETE in task manager under applications, Highlight the Linksys setup app, and click end task. Ok now go to Start, Run, type in regedit.

6. Once there go to edit in the menu bar, then to FIND, type in GTGINA.DLL

7. Registry finder will highlight entry, right click this and click rename.

8. Rename to GinaDLLOld.

9. Close Registry editor.

10. Restart windows.

You should have a windows login and when you do login you should be able to connect to your access point or wireless router.

This discussion is closed to new replies.