Networks

Ask something
Question Locked

Linksys wrv200 connection issues

0 helpful
5 replies

by kurt.foster

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a linksys wrv200 wireless router connected to the internet via a billion BiPac 5200. I am running a repair on the wireless connection anywhere between every 30mins to every couple of hours to keep it working. The connection shows up in the tray as having an excellent connection however i cannot see webpages, I also can't ping the BiPac when this issue occurs. after running the repair or power cycling the wireless router it starts working again.

I have the External IP setup as static, 192.168.1.2 and DHCP running from 192.168.96.100 - 192.168.96.104.

Does anyone out there have any idea of what could be causing this issue and how I might fix it?

5 replies

by peconet tietokoneet

If so, have you updated it's firmware? If no, then this will be your first port of call. Other than that i would get another router to see if it does the same, if it does then it would be your ISP's connection that is of no good.

by ic-it

external dns addressess to the computer, as well as the router's gateway.

by kurt.foster

thanks for the suggestions, I have already updated to the latest firmware. I have already added the DNS addresses but this cant be the issue as I can't ping any IP addresses. The issue is also not with the ISP as I can't even ping the adsl modem. I can also get a good connection if I plug straight into the modem.

by ic-it

Is the 192.168.1.2 the routers address on the LAN side?
If so then your network should also be handing out DHCP in that range.

Can you ping 127.0.0.1 ? That will check your TCP/IP stack.

Next try a tracert www.google.com
How far did it get?

This discussion is closed to new replies.