Discussion Locked

Load Balance 2 DSL Provider for one LAN

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Is there any products (hardware/Software) out there that can load balance 2 DSL providers for one local area network? (kinda like reverse webfarm) Assume that the DSL are using Static IPs of course.

I am running Windows 2000 Advance Servers. If Linux could do it, where can you point me in the right direction in getting some documentation.

BTW, I dont want to end up spending $1000s on a router just to do this. (But any information is greatly appreciated if that's the only way to go)

Thanks!
Tobias

5 replies

by mckaytech

There are a couple ways you can go. If you're talking about just balancing the two lines as far as Web browsing, you can use round-robin DNS running on a Linux router.

There's a cool Web site at www.linux-router.org where folks have done a lot of work with Linux routers and DSL and I seem to recall that the mailing list archives have some discussions about load balancing over multiple links. It might be a good starting point.

paul

by tobiasads

Round-robin DNS will allow people from the outside to view my "same" stuff on my different boxes. So it dont let ME browse OUT through ONE ISP or ANOTHER.

the www.linux-router.org is down :(

by Former member

h that would be linuxrouter.org, and it is free. Your load balancing would occur using equal-cost paths to the internet and using a routing protocol to support this such as OSPF. Otherwise, buy the hardware...

by tobiasads

I guess I have to go with a Linux box. This is what I need to find out; making sure linux lets me set equal-cost to "outgoing" paths.

and thanks for correcting the website link.

This discussion is closed to new replies.