Discussion Locked

Load error

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I work in a small two man IT shop. We are outsourced IT for several small businesses in the area. Recently we had a five second power outage that took down the server in our shop, heck of a time to find out that our UPS is bad. We really don't store any critical data on it. The server was running NetWare 5.0 and was mostly used for testing and experimentation, but there was some data on that I would like to have back.

Now when I turn it back on it POST's then comes up and says:

Load error.
Press a key to reboot?

When I hit a key it repeats the error.

Am I out of luck or can I reinstall without loosing data? What is the best coarse of action at this point?

This is more learning experience than it is critical but it would be nice to get it back.

Thanks in advance.

Justin Bohn
jcbohn@702com.net
IT Staff
Millennium Computers
Wahpeton, ND

5 replies

by dbarker

Justin;
sounds like you trashed a couple of files, maybe even the server.exe.

depending upon where those files are (and how good your backups are) there seems to be three options:

1 Check your BIOS setup to ensure it is correct and repair as necessary. reboot.
2 replace the dos partition with a backup and reboot.
3 reinstall the NOS but only replace the operating system - not the data. that is one of the options provided when you boot up with the install disk.
number 3 is the worst case scenario, you will have to put all your updates back in.

by colin_joseph

Ok, you have a couple options. If it was a shop computer, MOST LIKELY you didn't have any backups. Not the end of the world. Boot with a dos disk and check out the nwserver directory. Try to start the server with the server -ns switch to start abarebones startup. If it starts, you have to mount the partitions and run all the lines in autoexec startup.ncf manually to see where the problem is. If you cannot start, copy the server.exe file either from the netware 5 CD, or the latest servicepack that you installed on the server back into the \nwserver directory and start with the server -ns switch. If that doesn't work, copy the WHOLE startup directory of the netware5 cd into the nwserver directory on the server and try again.

If those don't work, you have a long, hard way ahead.

This discussion is closed to new replies.